I would like to receive the following free email newsletters:

Newsletter Signup
  1. Bridal Party
  2. Dining Out
  3. Kliman Online
  4. Photo Ops
  5. Shop Around
  6. Where & When
  7. Well+Being
  8. Learn more
Behind the Scenes: The Bureau of Engraving and Printing
What happens to your money before it leaves the factory? By Carol Ross Joynt
Assistant pressman supervisor Robert Phelan and pressman Michael Pate check the finished bills. Photograph by Ron Blunt.
Comments () | Published August 10, 2012

While not technically a “factory town,” Washington does have a large factory operating near the Tidal Basin: the Bureau of Engraving and Printing, which has been on DC’s 14th Street, Southwest, since 1914. What it makes is money—seven denominations of bills, to be precise. The nation’s only other money factory is in Fort Worth, Texas.

Money rolls off the presses in sheets of 32 $20 bills at a rate of about 100,000 sheets daily. It takes seven steps to print each bill, and all are made with a special paper blend by Crane & Co. The smell of fresh ink is pungent.

In the last stage of the process, shown here, the $20 bills go through a process called Currency Overprinting Processing Equipment and Packaging, in which they’re cut, stacked, and printed with Treasury and Federal Reserve bank seals before being shipped to the Federal Reserve for distribution.

This article appears in the August 2012 issue of The Washingtonian.


People & Politics
Subscribe to Washingtonian

Discuss this story

Feel free to leave a comment or ask a question. The Washingtonian reserves the right to remove or edit content once posted.
blog comments powered by Disqus

Posted at 10:25 AM/ET, 08/10/2012 RSS | Print | Permalink | Comments () | Articles